18
Wash/Rinse/Spin Individually
You can select the desired cycle combination, such as “wash and rinse” or “spin only”. (These are not
saved.)
Before you begin
Load clothes in the tub, close the lid, and turn on the water taps and the washing machine. ●
When the “Cotton” cycle is selected: 1
Press , or repeatedly to select the combination of cycles.
Select the water temperature (P.5) ●
Set the finish time (P.11) ●
Press 2 .
Change the water level (P.4) ●
About Detergent (P.20) ●
The selected cycles are complete when the washing machine beeps. ●
Setting the advanced options
Settings Used for Buttons used Remarks
Wash only Using washing liquid twice ●
The washing liquid stays in ●
the tub.
Wash and rinse Reusing the rinsing water ●
The rinsing water stays in the ●
tub.
Wash and spin
Washing clothes with ●
laundry starch
Rinse only Rinsing washed clothes ●
The rinsing water stays in the ●
tub.
Rinse and spin
Rinsing and spinning ●
washed clothes
Spin only
Spinning washed clothes ●
Draining water in the tub ●
Note
If you start from the “Rinse” or “Spin” cycle when the tub is filled with water, draining will take place first. ●
If the tub is empty, the “Spin” cycle will be performed first.
If you have used laundry starch, rinse off the starch after the cycle is complete. (Run the “Cotton” cycle ●
with the water level set to “Middle” or higher. Do not load any clothes.)
1$)6B*BHQJLQGG
To Next Page
Loading...
