Part names and functions of the controller
Controller
Touch Panel (EN17)
OFF/ON button
⁃
Starting massage operations
• The power of the controller is turned on.
• The power is automatically turned off when the
massage operation is completed.
⁃
Suspending ongoing massage operations
• The legrest goes down automatically, the backrest
rises, and the massage rollers are stored in the
original positions.
⁃
Setting and canceling child lock of the controller
Press the reclining angle adjustment button
Press to adjust.
⁃
Turn the power of the controller on to use the
massage lounger.
⁃
Backrest and legrest angles can be adjusted.
⁃
When holding down the adjustment buttons, chair
adjustment will continue until you hear the limit sound
(beep-beep-beep).
⁃
Armrests will move in conjunction with the reclining
of the backrest.
Setting and canceling the child lock
⁃
If this setting is made, the operations are no
longer accepted.
Ⱚ
How to set
Long press for about 5 seconds when the
power supply of the controller is OFF or when
the user selection / registration screen is being
displayed.
⁃
The following screen is displayed, and about
10 seconds later the power is switched OFF
automatically.
⁃
When is pressed after making the setting,
the following screen is displayed, and after
about 10 seconds, the power supply to the
controller is switched OFF automatically.
Ⱚ
How to cancel
Press and hold down for about 5 seconds
when the screen display described above is
shown or when the power of the controller is
turned off, in the set condition.
Emergency stop button
⁃
In case of emergency or feeling abnormal
sensations while in operations.
•
Press this button to stop the massage immediately.
• The legrest, backrest, and massage rollers will
not return to their storing positions.
•
Get off the unit body, being careful not to tip over.
• In order to use, press twice returning the
backrest and the massage rollers to their storing
positions, and then use again.
About language selection
The language selection screen will be displayed only
the first time when the control unit is activated.
(See EN35 for setting and changing)
EN16
To Next Page
Loading...
