11
AC operation
If you connect the AC adaptor to the clipper in the same
way as for charging, and turn on the power, you can use it.
• If the remaining battery is too low, the blades may
move slowly or stop, even with the AC operation. In
this case, charge the battery for 3 minutes or more.
• The battery will be discharged, even with the AC
operation.
Using the clipper
• Make sure that the clipper is turned off.
• Apply the oil to the clipper before and after each use.
(See page 16.)
• The appliance may not operate in an ambient
temperature approximately 0 °C or lower.
1
Mount the comb attachment and adjust the
trimming height as needed.
(See pages 11 and 12.)
• It can also be used without the comb attachment.
(Trimming height: approx. 0.5 mm)
2
Slide the power switch to turn on the
appliance.
Trimming hair
(See pages 12
and 13.)
Adjusting the
amount of hair
(See page 13.)
Trimming beard
(See page 14.)
Removing and mounting the attachment
• Take care not to injure hands, etc., with the blade when
removing or mounting the attachment.
Removing the attachment
Hold the main body securely and remove
the attachment from the main body.
Mounting the attachment
Mount the attachment to the main body
until it clicks.
• If the attachment is not attached
correctly, it may shift and end up cutting
too much during use.
How to adjust the trimming height
• Make sure that the clipper is turned off.
Turn the dial and adjust the trimming height
indication mark (
a
) to the desired height.
a
PB019062 - ER-GC52������_(01GB)_04-23-20.indd 11 2020/4/23 13:16:13
To Next Page
Loading...
