Panasonic ER-GC52 - Blade Life; Battery Life; Removing the Built-in Rechargeable Battery

18
English
Blade life
Blade life varies according to the frequency and period
of use of the clipper.
For example, the blade life is approximately 2 years
when using the clipper for 20 minutes twice a month.
Replace the blades if cutting efciency reduces
substantially despite proper maintenance.
Battery life
Battery life will vary according to the frequency and
length of use. If the battery is charged once a month, the
service life will be approximately 3 years.
If the operating time is signicantly shorter even after a
full charge, the battery has reached the end of its life.
Removing the built-in rechargeable
battery
Remove the built-in rechargeable battery before
disposing of the clipper.
The battery is to be disposed of safely.
Please make sure that the battery is disposed of at an
ofcially designated location if there is one.
This gure must only be used when disposing of the
clipper, and must not be used to repair it. If you
dismantle the clipper yourself, it will no longer be
waterproof, which may cause it to malfunction.
• Remove the clipper from the AC adaptor.
• Slide the power switch to turn on the power and then
keep the power on until the battery is completely
discharged.
• Perform steps 1 to  and lift the battery, and then
remove it.
• Take care not to short-circuit the positive and negative
terminals of the removed battery, and insulate the
terminals by applying tape to them.














PB019062 - ER-GC52������_(01GB)_04-23-20.indd 18 2020/4/23 13:16:21