Panasonic ER-GC52 - Troubleshooting

17
English
Troubleshooting
Problem Action
The blade has not
been cleaned
properly.
When the clipper is very dirty,
remove the blade and wash
with water. (See pages 15 and
16.)
Makes a loud
sound.
Conrm that the blade is
properly attached.
The clipper has
become blunt.
Replace the blade.
(See page 16.)
Clean the blade and apply oil.
(See pages 14 to 16.)
Clipper stopped
functioning.
Operating time
is short.
Charge the clipper.
Or use with the AC operation.
(See pages 10 and 11.)
Charge the battery for
approximately 16 hours
continuously to rejuvenate it.
If few uses remain even after
charging, the battery has
reached the end of its life.
(Fluid may be leaking due to
degradation at the end of
battery life.)
Contact an authorized service
centre for repair.
Problem Action
The clipper cannot
be charged.
Push the appliance plug into
the main body all the way and
make sure the charge indicator
lamp ( ) glows.
Charge within the
recommended charging
temperature of 0 °C to 35 °C.
Clipper can be
used for only about
10 minutes even
after charging.
Have the battery replaced by an
authorized service centre.
If the problems still cannot be solved, contact the store
where you purchased the unit or a service centre
authorized by Panasonic for repair.
PB019062 - ER-GC52������_(01GB)_04-23-20.indd 17 2020/4/23 13:16:20