Panasonic ER-GC52 - Trimming Beard; Trimming to an Even Length; Trimming the Downy Hair; Maintenance

14
English
Trimming beard
• Do not use with shaving foam applied or when the
beard is wet.
A wet beard may stick to the skin or bunch up, making
it difcult to trim.
• Before trimming, comb your moustache with a comb.
Trimming to an even length
Holding the clipper with the power
switch facing outwards, trim by
bringing the blade in contact with
the skin and moving the clipper
against the ow of the beard.
• Hair trimmings may collect inside the
comb attachment when a large
volume of beard is cut, so discard hair
trimmings after each use.
Trimming the downy hair
Without comb attachment
Holding the clipper with the power
switch facing outwards, trim by
bringing the blade in contact with
the skin.
• The clipper cannot trim hair to
lengths less than 0.5 mm.
Maintenance
• Clean the clipper and the blade after each use.
(If not cleaned, the motion will become poor and the
sharpness will worsen.)
• Make sure that the clipper is turned off.
• Remove the clipper from the AC adaptor.
• Do not use thinner, benzine, alcohol or other
chemicals. Doing so may cause failure, cracking or
discoloration of the main body. Clean the main body
only with a soft cloth slightly dampened with tap water
or soapy tap water.
PB019062 - ER-GC52������_(01GB)_04-23-20.indd 14 2020/4/23 13:16:17