Panasonic ER-GC52 - Cleaning with Water; Cleaning with the Brush

15
English
Cleaning with water
Main body, blade and attachment
To remove light dirt To remove heavy dirt
1. Remove the attachment
and turn the clipper on.
2. Run water down the
water inlet at the front
of the main body, rinse
thoroughly for
approximately 20
seconds, and then turn
the clipper off.
1. Remove the attachment
and blade.
2. Clean the clipper, the
blade and the
attachments with
running water.
• Shake up and down several times to remove the
water.
• Be careful not to hit the main body on the sink or
any other object while draining the water. Failure to
do so may cause malfunction.
3. Wipe off the water with a towel
and let it dry naturally.
• It will dry faster with the blade
removed.
4. Apply the oil to the blade after
drying. (See page 16.)
5. Attach the blade and
attachment to the main body.
The mark on the left means suitable for
cleaning under an open water tap.
Cleaning with the brush
Main body and blade
• Remove the blade. (See page 16.)
1. Brush off any hair trimmings
from the main body and from
around the blade.
2. Brush off the hairs from the
blade edge.
PB019062 - ER-GC52������_(01GB)_04-23-20.indd 15 2020/4/23 13:16:18