13
Shaping your sideburns
Without comb attachment
Holding the clipper with the power switch at the
bottom, keep the blade at an angle of 90° against the
sideburns and move the clipper from top to bottom
along the skin to trim the sideburns.
Trimming the downy hair around the neckline
Without comb attachment
Holding the clipper with the
power switch at the bottom,
touching the blade perpendicular
to the area of downy hair, and
move the clipper downward
along the skin.
90°
Trimming to an even length
Holding the clipper with the
power switch facing outwards,
trim slowly while crisscrossing
from various directions to
avoid missing any spots.
Notes
• It is recommended to ask someone else to trim around
your own ears and neckline.
• The desired results may not be achieved if hair is too
long. In this case, trim the hair to a length of about
20 mm before using the clipper.
Adjusting the amount of hair
How to adjust the overall amount of hair
Attach the natural attachment and cut the hair
against the hair grain from the front, both sides and
back to the top of the head.
From the front From both sides From the back
• Move the tip of the natural attachment along the scalp.
• Please adjust by increasing or decreasing the number
of cuts while checking the nish.
Notes
• The clipper may not be able to cut hair with a length
less than 30 mm.
PB019062 - ER-GC52������_(01GB)_04-23-20.indd 13 2020/4/23 13:16:16
To Next Page
Loading...
