Panasonic ES-CM3A - Page 16

16
English
3
Store this product after drying it.
a Remove the outer foil section and
the shell, thoroughly dry the main
body.
• Leave this product dry in the
shade, out of direct sunlight.
b After this product is dried
completely, install the outer foil
section and the shell onto the
main body.
• Refer to pages 18 and 19 and the following schematic
diagram for the method of installation and removal.
• Perform the following operations after installing the outer foil
section onto the main body:
To disassemble the shell (
a
):
1 Hold the enclosure and forcefully
squeeze both sides of the
enclosure.
2 Hold the gray part in the gure
with the other hand
and gently pull it upwards.
3 Pull the enclosure down.
①
①
②
③
a
To install the shell (
a
):
1
Attach the socket cover onto the
hole of the shell (
a
).
2
Attach the shell (
a
) onto the
main body until a “click” sound
is heard while keeping the
trademark on the shell (
a
) on
the same side as the power
switch.
1
2
a
PB023037 - ES-CM3A �����_(01EN)_12-20-23.indd 16 2023/12/20 11:42:34