Panasonic ES-CM3A - Cleaning

15
English
■ How to improve the shaving effect
• Apply the whole system outer foil
perpendicularly against the skin and shave
by slowly sliding this product over the face
against the grain of the beard.
• To prevent damaging the system outer foil, do
not shave with only a part of the system outer
foil.
• The beard under the chin and around the
throat can be shaved better by stretching the
skin so the beard will stand.
90°
► Notes
• It is recommended to clean this product after each use.
• After wet shaving, clean the main body with water and then
apply oil on the system outer foil.
Cleaning
• Power off this product and unplug the USB cable from the main
body.
• Check that the socket cover is closed.
1
Apply a small amount of hand
soap and water on the system
outer foil.
Power on this product, leave it
run for 10 to 20 seconds, and
then power it off.
2
Press the foil frame release
buttons to remove the outer foil
section.
(See pages 18 and 19)
Clean this product with running
water.
• After rinsing with water, wipe off
any excess water with a dry cloth.
PB023037 - ES-CM3A �����_(01EN)_12-20-23.indd 15 2023/12/20 11:42:33