20
Wet cleaning [
A
B
C
D
F
H
]
Epilation head/Shaver head
(Fig. 21)
1. Wet the discs and blades, and then
apply liquid hand soap.
2. Turn the switch on and then foam
is created.
3. Wash the head with water to wash
out hair.
•Do not use hot water.
•
If soap is not completely washed
away, then a white deposit can
accumulate and prevent the discs
and the blades from moving smoothly.
•Rinse the shaver head with the
frame removed.
4. Turn the switch off, wipe the appliance
with a dry cloth and dry it well.
Foot care head
(Fig. 22)
1. Apply liquid hand soap to the
central part of the le.
2. Pour a small amount of water on
the le and turn the switch on.
3. Rinse any debris thoroughly with
water or lukewarm water.
4. After turning the switch off, remove
the frame and rinse inside.
5. Wipe with a dry cloth and dry in a
well‑ventilated location.
Replacing the outer foil and
the inner blade
We recommend replacing the outer foil
[
F
8
] every year and the inner blade
[
F
] every two years. Remove the
outer foil of the shaver head [
F
] only
when replacing it.
Replacing the outer foil
(Fig. 23)
1. While pushing the outer foil gently
with the ngers, use a ngernail to
release the plastic panel ( ) on the
blade from the hooks (
) on the
inside of the frame.
2. The new outer foil should be
slightly bent and pushed in until it
is hooked in the frame.
Replacing the inner blade
(Fig. 24)
1. Remove the inner blade by holding
it at both ends and pulling straight
away from the shaver.
2. Insert the inner blade by holding it
at both ends and press downward.
Replacing the le
Thelelifetimeisapproximately1year
(assuming a single use every 2 weeks
with approximately 10 minutes per use).
Werecommendreplacingtheleabout
once a year.
1. Press down with your nger and
release the le.
2. Align the shaped part with the
mark side and press down. (Fig. 25)
PB015615 - EL8A-3A-2A������_(01GB)_11-07-17.indd 20 2017/11/7 11:11:23
To Next Page
Loading...
