Panasonic ES-LL41 - Cleaning the Shaver; Cleaning with Water and Trimming Notes

16
Trimming
height (mm)
(approx.)
Corresponding position of trimming height lever
and trimming height mark
1 mm
1 2 3
1 mm
1 2 3
2 mm
1 2 3
3 mm
2 mm
3 mm
5 mm
5 6 7
5 mm
5 6 7
6 mm
5 6 7
7 mm
6 mm
7 mm
4. Turn the shaver on, bring the
comb of the comb attachment
into contact with the skin, and
cut the beard by moving the
trimmer.
Notes
•Becarefulnottocutyourhandonthebladewhenattaching
and removing the comb attachment.
•Hairtrimmingsmaycollectinsidethecombattachmentwhen
a large volume of beard is cut, so discard hair trimmings
after each use.
•Ifthecombattachmentisnotattachedproperly,itmay
become loose during use resulting in excessive cutting.
•Sometimesthebeardmaybelongerthanthesettrimming
length.
•Ifthebeardistoolong,thetrimmingresultmaybeaffected.
Please cut your beard to about 2 cm in length before using
the trimmer.
Cleaning the shaver
We recommend cleaning the shaver after each use.
Cleaning with water
•TurntheshaveroffanddisconnecttheACadaptor.
1. Apply some hand soap and
some water to the system
outer foil [
A
2].
ES‑LL21������.indb16 2018/6/1911:47:43