Panasonic EW3006 - Q&A

Q&A
Q Why are the blood pressure values measured at home different
from those measured at the doctor's office?
Blood pressure varies 24 hours a day.
A In addition, it can change greatly depending on the weather, your
= mental state,exercise,etc.
In particular,there is the phenomenon of "White uniform hypertension"
at doctor's offices, where the blood pressure measured in a doctor's
office is higher because of stress or worry.
In addition, if the blood pressure measured at home is higher than
that measured at the doctor's office, the following points should
be considered and care should be observed where necessary:
(DThe blood pressure monitor is not at the same
height as the heart.
If measurements are taken with the blood
pressure monitor lower than the heart,the
measured blood pressure values will be
higher.
yo?
Ke (2)The pressure cuff is wrapped loosely.
or” Wrap the pressure cuff securely around the wrist.
(3)Do you feel worried or irritated?
Before taking measurements, take 2 or 3 deep
breaths ang relax to stabilize blood pressure.
Oy,
Q Why are measured blood pressure values different each time |
take a measurement?
(1)Blood pressure varies throughout the day, and
A. can also vary depending on how the pressure
cuff was wrapped or your posture.
- Because of this, measurements should be taken
2) at the same time and under the same conditions
Sea, every day.
(2)For persons taking blood pressure medication,
blood pressure may change greatly due to the
effects of the medication.
J 一
(3)When taking 2 measurements in succession,
be sure to stay quiet for 4 to 5 minutes after
G the first measurement before taking the next
measurement.
37
Q&A
Q Why are the measured values different for the left and right wrist?
It is said that differences in blood pressure values
between the left and right wrists may be around
10 mmHg. The blood pressure monitor can take
measurements on either the left or right wrist,
but all measurements should be taken using the
same wrist.
Q The " Movement Detection" symbol is not displayed while
the hand or the wrist is moving, why?
The "Movement Detection Function" is a function that detects excess
~“ pressure on the sleeve strap which is caused by movement of the
use's during measurement and displays the "Movement Detection"
symbol when this occurs. Because of this,the"Movement Detection"
symbol may not be displayed if the movement does not affect the
sleeve strap.
If you are unsure about the measurement, please do it again.
Q The measured value is unusually higher although the
position of the hand and the wrist is fixed according to
the indication of "Movement Detection" symbol, why?
A. The " Movement Detection" symbol is just a reference indication for
correct measurement posture (see p.30).
If the measured value is unusually higher or lower after the symbol of
"Movement Detection" is displayed, please measure again.
If the above situation occurs,the following factors may exist:
slIncorrect measurement method (the binding method of sleeve
strap, posture, etc)
Please refer to the methods of pp.26 and 28.
e Measurement immediately after smoking.
e Measurement when user's mood is not steady.
e Measurement in cold circumstance.
e The change of user's pulse is small.
If you are unsure about the measured value, please measure
again after 4-5 minutes rest.
38