Panasonic EW3006 - Troubleshooting

41
TROUBLESHOOTING
Cause and solution
Pressurization to more | Were measuremntes
than 280 mmHg was taken according to the
performed. proper procedure and
in the correct posture?
Display
Remeasure"E"mark
is displayed.
Pressure decreased
suddenly and the
remeasure mark"E"
appeared.
(See pp.27 ~ 28.)
Was the pressurization
The heart marky cuff wrapped properly?
blinked only a few
times or not at all.
(See p.26.)
No pressurization.
Has the unit detected
movement?
(See p.30.)
Your hand or wrist
moved.
Systolic or diastolic
blood pressure value
is high or low.
Possible cause
è During measurement,the level of the
instrument was higher or lower than the level
of the heart.
e The pressure cuff was not wrapped properly.
eYou moved or talked during measurement.
(See pp.26 to 28.)
Value is different from
that measured by the
doctor.
Blood pressure varies in response to minute
changes in your mental state, such as your
reaction to the doctor's presence.
e Relax 4 or 5 minutes, and take another
measurement.
Measurement values
are different with each
measurement.
(See
pp.27
~
28.)
Symptom
Possible cause
*Batteries are installed backwards.
(See p.25.)
No display appears even
when the 开始 /结束 button
is pressed.
When the Start/Stop
button is pressed,the
display disappears during
pressurization (xi mark
appears).
eBatteries are exhausted.
(See p.25.)
The CZW mark
flashes when readings are
being taken.
*There was a singificant fluctuation in
pulse when readings were being taken
(See p.31.)
The & mark flashes
when readings are being
taken.
eYour hand or wrist moved.
(See p.30.)
en some cases this will be displayed
when you have tensed the muscles in
your arm.
Relax the muscles in your arm and
take the reading again. (See p.30.)
The es mark flashes
even though | did not
move my hand or wrist.
Since measurements are performed
during pressurization,there may be
changes in operating sounds or the
pressurization rate during
pressurization. This is normal and is
not a malfunction.
During pressurization, the
sound or pressurization
rate changes.
Do not repair it yourself. Please
contact our designated service
agency for wrist blood pressure
monitors to examine and repair
the device.
Damage of the main unit.
*The warranty of this product is only valid in the PRC.
(Not available in Hongkong, Macao and Taiwan for the time being.)
42