EasyManua.ls Logo

Panasonic FP-E - Page 1084

Panasonic FP-E
1334 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
Precautions Concerning Programs
4-32
4.9 Processing During Forced Input and Output
4.9.1 Processing when forced input/output is initiated during RUN
Forced reset/reset processing
Input/output update
Forced reset/reset processing
Operation
Forced reset/reset processing
Peripheral service
A
B
External input → X
External output → Y
PLC
1. Processing of external input (X)
Regardless of the state of the input from the input device, forced on/off operation will
take precedence at a contact specified for forced input/output in the above procedure
B. At this time, the input LED will not blink, however, the area of input X in the operation
memory will be rewritten.
Contacts not specified will read in the on/off state according to the condition of the inptu
from the input device.
2. Processing of external output (Y)
Regardless of the result of operation, forced on/off will take precedence at a contact
specified for forced input/ouput in the above procedure A. At this time, the area of output
Y in the operation memory will be forcedly rewritten. External output will take place
according to the input/output update timing in the above diagram.
The on/off state of contacts not specified will be determined by the operation result.
3. Processing of Timer (T) and Counter (C)
Regardless of the timer/counter input condition, forced on/off operation will take
precedence at a contact specified for forced input/output. At this time, the contact of the
timer (T) or counter (C) in the operation memory will be rewritten. Timing and counting
will not take place during control.
The on/off state of contacts not specified will be determined by the operation result.
Phone: 800.894.0412 - Fax: 888.723.4773 - Web: www.clrwtr.com - Email: info@clrwtr.com