EasyManua.ls Logo

Panasonic FP-E - Page 1083

Panasonic FP-E
1334 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
4.8 Rewrite Function During RUN
4-31
4.8.3 Procedures and Operation of Rewrite During RUN
Item FPWIN GR
Ladder symbol mode
FPWIN GR
Boolean mode
Rewrite procedure Maximum jof 128 steps.Changes are per-
formed by block.When PG conversion is
executed online, the program will be re-
written.
Block a Block b
Rewriting performed by step.Caution is
required as rewriting takes place simulta-
neously with the change.
Operation
of each
instruciton
OT/KP If an instruction written in block a is de-
leted in block b, the condition before the
rewrite will be held.s
If an instruction written in block a is de-
leted in block b, the condition before the
rewrite will be held. Y contact relays
which are on bill be held in the on sattus.
To turn them off in the RUN mode, use
forced output.
TM/CT − If an instruction written in block a is de-
leted in block b, the condition before the
rewrite will be held.
− Set values specified by K constants in
TM/CTinstructions are preset in all of the
corresponding SV’s in the program.
(Elapsed values EV do not change.)
− If an instruction written in block a is de-
leted in block b, the condition before the
rewrite will be held.
− Set values specified by K constants in
TM/CTinstructions are preset in all of the
corresponding SV’s in the program.
(Elapsed values EV do not change.)
Fun
High−level
instructions
If an instruction written in block a is de-
leted in block b, the condition before the
rewrite will be held.
− If deleted,theoutput memory areawill be
held.
MC/MCE When writing MC/MCE instructions, be
sure to write the instructions as a pair.
Writing or deleting a single instruction dur-
ing RUN is not possible. Write or delete the
instruction in FPWIN GR ladder symbol
mode.
CALL/SUB/
RET
A subroutine is a program appearing be-
tween SUBn and RET instructions. Be
sure to write it to an address which fol-
lows the ED instruction.
Write in the order: RET, SUB, CALL
Delete in the order: CALL, SUB, RET
INT/IRET An interrupt program is an program ap-
pearing between INTn and IRET instruc-
tions. Be sure to write it to an address
which follows the ED instruction.
Write in the orde: IRET, INTDelete in the
order: INT, IRET
SSTP/STPE A distance with the same number cannot
be defined twice. An SSTP instruction
cannot be written in a subprogram.
Writign and deletion of a single instruction
is not possible for a program with no step
ladder area.Write or delete both instruc-
tions simultaneously in FPWIN GR ladder
symbol mode.
In the case of an SSTP instruction only,
writing and deletion of a single instruction
is possible for a program with a step lad-
der area.
JP/LOOP/
LBL
Be sure to write the instruction for setting
the loop number before LBL −LOOP in-
structions.
Write in the order: JP−LBL or LOOP−
LBLDelete in the order: LBL−JP or LBL−
LOOP
Phone: 800.894.0412 - Fax: 888.723.4773 - Web: www.clrwtr.com - Email: info@clrwtr.com