5-130
5.1.15 Table of Special Data Registers for FP-X
FP-X (A: Available, N/A: Not available)
Address
Name Description
Read
-ing
Writ-
ing
DT90000
Self-diagnostic error
code
The self-diagnostic error code is stored here
when a self-diagnostic error occurs.
A N/A
DT90001 Not used - N/A N/A
When an error occurs at the I/O board for the
application cassette, the bit corresponding to
the board will be set on.
DT90002
Position of abnormal
I/O board for
application cassette
A N/A
DT90003 Not used - N/A N/A
DT90004 Not used - N/A N/A
DT90005 Not used - N/A N/A
When an error occurs at the intelligent board
for the application cassette, the bit
corresponding to the board will be set on.
DT90006
Position of abnormal
application cassette
A N/A
DT90007 Not used - N/A N/A
DT90008 Not used - N/A N/A
DT90009
Communication error
flag for COM2
Stores the error contents when using COM2
port.
A N/A
When the state of installation of FP-X
expansion I/O unit has changed since the
power was turned on, the bit corresponding to
the unit No. will turn on. Monitor using binary
display.
DT90010
Extension I/O verify
error unit
A N/A