Panasonic FP-E - Page 229

Basic Instructions
2 − 119
Outline This changes the communication conditions for the COM port or Tool
port based on the contents specified by the character constant.
Program example
Ladder
Diagram
Boolean Non-ladder
Ladder Diagram
Address Instruction
Trigger
10
R0
SYS1, M
S
DF
SYS1, M
S
No. 2
keyword
No. 1
keyword
COM1,19200
COM1, B8POS1
10
11
12
25
ST
DF
SYS1
M
SYS1
M
R0
COM1, B8POS1
COM1,
19200
S Character constant “M”
Operands
O
p
erand
Relay Timer/Counter Register
Index
register
Constant
Index
modifier
Operand
WX WY WR WL SV EV DT LD FL I K H M
modifier
S N/A N/A N/A N/A N/A N/A N/A N/A N/A N/A N/A N/A A N/A
Explanation of example
When R0 turns on, the transmission format and baud rate for the COM. 1 port are set as follows.
Character bit: 8, Parity: Odd
Stop bit: 1
Baud rate: 19,200 bps
Description
The communication conditions for the port specified by No. 1 keyword are changed to the contents specified
by No. 2 keyword.
Contents that can be changed include the following:
1) Communication format
2) Baud rate
3) Unit No. For FP0R, indirect settings are available.
4) Header and Terminator
5) RS (Request to Send) control
FPΣ/FP−X/FP0R
SYS1
Availability
FPΣ/FP−X/FP0R
Communication conditions setting
A: Available
N/A: Not Available
Phone: 800.894.0412 - Fax: 888.723.4773 - Web: www.clrwtr.com - Email: info@clrwtr.com