High−level Instructions
3 − 363
For information on the contents of error codes, refer to the manual. If the error code is H73, a communication
time−out error has occurred.
The time−out time can be changed within a range of 10.0 ms to 81.9 seconds (in units of 2.5 ms), using the
setting of system register 32.
The default value is set to 10 seconds.
Error code (HEX) Description
73 Time−out: Waiting for response
The F145 or F146 instruction cannot be executed if the target is a special internal relay (from R9000)
or a special data register (from DT9000) or file register FL.
FPΣ/FP−X/FP0R
To Next Page