High−level Instructions
3 − 377
2
Example of bit unit reception
When the control data is as follows:
DT10(S1)=H850D
DT11(S1+1)=H01
0A
Bit unit
Unit No.10
Route No.1
Bit No. 13 of remote station’s memory area
Bit No. 5 of local station’s memory area
the on and off information of Bit No. 13 of DT100 of the unit No. 10 connected to route No. 1 is sent
to Bit No. 5 of DT50 when the execution condition (trigger) R0 turns on.
Description
This reads the data in the area specified by S2 and N of a remote station connection with the MEWNET−W,
MEWNET−P, MEWNET−H, and stores it in the area specified by D of the local station.
The remote stations (routes and unit numbers), the transmission unit (bit unit or word unit), the transmission
method, and other parameters are specified by the control data S1.
DS2N
(Receiving request)
Data
Link
unit
CPU
Local
station
Remote
station
The remote station is specified by S1.
If general−purpose communication through the COM. port of the FP2, FP2SH, and FP10SH is being used,
F144 (TRNS) instruction is used instead of this instruction.
Refer to the section describing the F144 (TRNS) instruction.
To Next Page