High−level Instructions
3 − 383
2
Specifying the relay station
S+1 should be used to specify only the specified amount of depth, while (S1+3) is used to specify
depth 2 for the same item, and (S1+4) is used to specify depth 3.
Route No. of relay destination in depth 1: H01 to H08
S1+2:
Unit No. of relay source in depth 1: H01 to H40 (1 to 64)
3
Specifying the remote station
This should be specified right after the specification of the relay station.
Specifies H00
S1+n:
Unit No. of remote station: H01 to H40(1 to 64)
(n = depth + 2)
Example: When using the program example shown on page 3 − 376.
In this example, the data from DT100 to DT104 of the CPU (CPU5)
is received in DT50 to DT54 of the local station (CPU1) shown
below.
No.2
No.4
No.16
No.10
4321
3211
321
DT100
to
DT104
DT50
to
DT54
Power
CPU 1
Link
Power
CPU 2
Link
Link
Link
Power
CPU 4
Power
CPU 3
Link
Link
Link
Power
CPU 5
Link
Connection diagram
To Next Page