High−level Instructions
3 − 447
Using the FP−X
High−speed counter and Pulse output controls flag area
The area DT90052 for writing channels and control codes is allocated as shown below.
The control code written by the F0 (MV) instruction is stored in the control code monitor area while it is written
in the special register DT90052. (Refer to the table below.)
The written data is the data for lower 8 bits only.
High−speed counter and Pulse output controls flag area of FP−X
15 12 11 8 7 4 3 0
Near home input
0: Enable
1: Disable
Stop pulse output
0: Continue
1: Stop
Count
0: Permit
1: Prohibit
Software reset
0: No
1: Yes
DT90052:
Channel specification
H0 to H3: CH0 to CH3
H1 fixation
(PLS)
Program example
Example 1: Software reset of Pulse output
R0
DF F0 MV, H101, DT90052
F0 MV, H100, DT90052
(ch0)
R0
DF F0 MV, H1101, DT90052
F0 MV, H1100, DT90052
(ch1)
FP0/FP−e/FPΣ/FP−X/FP0R
To Next Page