Panasonic FP-E - Page 835

High−level Instructions
3 − 571
Outline Sets the 32−bit ON−delay timer for 0.01 s units (0.01 to 21474836.47 s)
Program example
Ladder
Diagram
Boolean
Ladder Diagram
Address Instruction
10
F183 DSTM , DT10 , DT 5
S
D
Trigger
R0
R5
10
11
16
ST R 0
F183 (DSTM)
DT 10
DT 5
OT R 5
S 32-bit equivalent constant or lower 16-bit area of 32−bit data for timer set value
D 16-bit area for timer elapsed value
Operands
Operand
Relay Timer/Counter Register
Index
register
Constant
Inde
x
Operand
WX WY WR SV EV DT
IX
(*1)
IY K H
Index
modifier
S A A A A A A A N/A A A N/A
D N/A A A A A A N/A N/A N/A N/A N/A
(*1) With the FP0R, FPΣ,FP−X, FP2, FP2SH, and FP10SH, this is I0 to IC.
Explanation of example
When the execution condition (trigger) has been satisfied, the auxiliary timer is activated, and the time equal
to the values stored in data registers DT10 and DT11 x 0.01 seconds has elapsed, R5 goes on.
Description
This functions as a 32−bit addition−type On Delay timer set in 0.01−second units.
When the execution condition (trigger) is on, the elapsed time is added, and when the elapsed value (D + 1, D)
(32 bits) exceeds the set value, the relays being used are turned on by the OT instruction which comes next in
the program.
When the execution condition (trigger) is off, the elapsed value area is cleared to 0, and relays being used are
turned off by the OT instruction.
When the time set for the special internal relay R900D has elapsed, the relay is turned on.
R900D can also be used as a timer contact.
(R900D is off when the execution condition (trigger) is off and while addition is being carried out.)
R0
R900D R5
F183 DSTM, DT10, DT5
Operation is the same as that in the example shown above.
Auxiliary timer (32-bit )
5
F183
(DSTM)
A: Available
N/A: Not Available
Phone: 800.894.0412 - Fax: 888.723.4773 - Web: www.clrwtr.com - Email: info@clrwtr.com