Black
White
Green
Blue
Wire connectors
Switch
Flex-Z Fast™ bracket
Circular exhaust duct
Conduit
Install the circular exhaust duct and secure it with
clamps or ties and seal it with mastic or approved
foil tape. A 3 or 4 inch circular duct is needed to
connect to the relevant part of the adaptor.
Remove screw from junction box cover and secure
conduit or stress relief to junction box knock-out hole.
2
1
Connect wires
Install circular exhaust duct
Refer to WIRING DIAGRAM. (Page 5)
Follow all the local electrical safety codes as well as the National Electrical Code (NEC). Use UL approved wire
connectors to connect fan wires. After connecting wires, replace junction box cover.
1
Junction box cover
1
2
Joist
Adaptor
INSTALLATION (RETROFIT) CONTINUED
1
Install the adaptor to the Flex-Z Fast™ bracket by using 2 self-drilling screws.
1
Install adaptor
2 Self-drilling screws
Circular exhaust duct
Conduit
1
Self-drilling screw
Drywall
Joist
6
Extend bracket to the other joist.
Install bracket to just using 2-preinstalled
tapping screws
5
6
2 Tapping
screws
(ST4.2X20)
Extend
5
7
English
Live (Light)
Neutral
Conduit
Live (Fan)
Neutral
Live
(Night Light)
Earth ground
L
N
AC 120 V 60 Hz
(Power supply)
Earth ground
Switch box
To Next Page
Loading...
