Panasonic FZ-M1 Series - Using the Bluetooth Function

<Only for model with Bluetooth>
You can access internet and other Bluetooth devices without connecting cables.
 Communication is established through the Bluetooth antenna (A). Do not block the antenna area with your hand or body.
 To use Bluetooth, set [Bluetooth] of [Wireless Configuration] to [Enabled] (default) in the [Advanced] menu of the Setup Utility.
 The transmission rate will be lower when a microwave oven is used near by.
 When you uninstall the Bluetooth Driver, turn Bluetooth off.
Using the Bluetooth Function
Before using a Bluetooth, turn the Bluetooth communication on.
Turning on/off the Bluetooth communication
1. To enable the wireless communication ( Disabling/Enabling Wireless Communication).
2. Touch (Settings) - [Network & Internet] - [Airplane mode]*1 to [Off].
Alternatively, touch (Start) - (Settings)-[Network & Internet]-[Airplane mode]
*1 to [Off] in the desktop mode.
3. To turn off the Bluetooth communications, set [Bluetooth] to [Off].
To turn on the Bluetooth communications, set [Bluetooth] to [On], and then;
*1 : Screen messages are explained in [English (United States)].
(Depending on the language preference, some screen messages in these instructions are different from the actual screen
messages. For example, [Flight mode] may be displayed instead of [Airplane mode] in some language preference.)
To check the Bluetooth communication status
1. Touch (Settings) - [Devices] - [Bluetooth].
Alternatively, touch (Start) - (Settings) - [Devices] - [Bluetooth] in the desktop mode.
 You can also touching on the task tray, and then touch (Bluetooth) - [Show Bluetooth Devices] to
check the communication status.
Bluetooth
NOTE
NOTE