26
6 Service Mode
1. Indication method of the service menu
Set the mode switch “Motion Picture Recording” mode.
2. While the power is turned OFF, keep pressing the “Power” button, “Zoom lever” to W side and “intelligent auto/Manual” button
for more than 3 seconds until the top screen of the Service Mode Menu being displayed.
Service mode menu
NOTE:
Do not using service mode except above table of Service mode menu.
3. End method of the top screen of the service mode menu
Touch the [ EXIT ] of LCD to end the service mode, and then POWER OFF.
Screen display Contents Function
1 Factory settings Function to throw a product up in a factory shipment state
(When recorded data in Built-in memory, “error display” is done)
3 Built-in memory self check execution
(HC-X920M only)
Function to check self as for the state of Built-in memory
4 Lock search history indication Display the camera system error cord for three histories saved
in EEPROM
5 Power ON self check result display Power ON self check (function to diagnose correct function of
the device and interface between devices) result display
9 Forced full flash emission Forced full flash emission for discharging the capacitor on
FLASH P.C.B. and set to prohibit charge
10 Erasing the lock histories Erasing the error histories (working time is not erased)
12 Camera data indications while the
video playback
Display the camera informations (Shutter speed, Iris value,
White balance and focal length) while playing recorded video
14 Adjutment function for the service The service adjustment do setup and adjustment of the follow-
ing items required in the field service.
15 Restore the backed up adjustment data Restore the adjustment data to new or repaired Main P.C.B.
from SD card that the data backed up from original Main P.C.B.
before repairs or replacement.
16 Touch panel calibration Calibrate the touch positions of the touch panel.
To Next Page
Loading...
