Theunitisputintorecordingpauseapprox.1secondwhentheunitisturnedonwiththe
modesetto_ orO.
• Dependingontherecordingconditions,starttimemaybelongerthan1second.
• IntheQuickpoweronmode,thezoommagnificationbecomes1×.
Thisunitisputintorecordingpauseapprox.0.6secondsaftertheLCDmonitorisreopened
ortheviewfinderisextended.
• When in Quick start standby mode about 80% of the power used in Recording pause
mode is being consumed, so the recording time will be reduced.
• Quick start will not work if there is no SD card inserted.
• Change the mode to _ or O.
1 Set [QUICK START] to [ON],
2 Close the LCD monitor and retract the
viewfinder while the mode is set to
or _,
The status indicator O flashes green and the unit
goes into Quick start standby mode.
• The lens cover does not close.
3 Open the LCD monitor or extend
the viewfinder.
The status indicator O lights red and the unit
is put into recording pause.
• Quick Start Standby Mode is canceled if
about 5 minutes have elapsed
mode is set to []
• Time for Quick start will be more than 0.6 seconds slower when the Digital cinema is used.
• Depending on the recording conditions, time for Quick Start may be more than 0.6 seconds
slower in Still Picture Recording Mode.
• It may take some time for Automatic white balance to adjust.
• In the Quick Start Mode, the zoom magnification becomes 1×.
• If [ECONOMY] (-) 43) is set to [5 MINUTES] and the unit automatically goes into Quick
Start Standby Mode, close the LCD monitor and viewfinder and then open the LCD monitor
or extend the viewfinder again.
• Turn the unit off using the power button.
• Quick start standby mode cannot be released by the remote control.
44
VQT3B18
To Next Page
Loading...
