EN-10
Using the Oven
Start/Pause/Cancel Function
1. For every function, press to start operating the function.
2. Press
once to pause the function. To resume the function, press .
3. Press
twice to cancel the function.
Lamp Setting
1. Press once, will be visible on the display.
2. Press
to switch on the lamp. (No heating takes place.)
3. Press
twice to switch off the lamp.
Inquiring for Time
While cooking is in progress or the reminder was set, press to see the current
time�
Child Lock Function
To Lock: Press and hold and simultaneously for approximately 3 seconds,
beep will sound and
will be visible on the display� All controls will be
disabled�
To Unlock: Press and hold
and simultaneously for approximately 3 seconds,
beep will sound and
will go off� All controls are ready for use�
■ Note:
Alternatively to unlock the Child Lock, switch OFF the power supply.
Switching display from °F to °C
The default temperature setting display is °F.
1. Press
3 times. will be visible on the display.
2. Press
.
3. Press
again and hold for approximately 3 seconds.
4.
°C will be visible on the display.
5. The display will change to clock indicating the current time.
Follow the same steps when switching display from °C to °F.
■ Note:
•
Setting will be effective unless the plug is disconnected. Once the circuit breaker is
turned off or power failure occurs, the display setting will return to °F.
•
Press twice when you cancel the procedure after performing step 2. Otherwise, the
oven will start heating and continue for 9 hours.
To Next Page
Loading...
