EN-24
Installation Instructions
■ 4-Wire Branch Circuit
Refer to Figure 2:
•
Disconnect ground from neutral at free
end of conduit.
•
Connect the green GROUND wire from
the oven to the GROUND wire in the
junction box (bare or green colored wire).
•
Connect the red and black leads from the
oven to the corresponding HOT Wires in
the junction box.
•
Connect the white wire from the oven to
the NEUTRAL (gray or white) wire in the
junction box.
•
Connect the local codes and power
supply codes using a terminal.
•
The terminal uses a thing adapting to the
wire of the cord.
Ungrounded Neutral
Cable from
power supply
Cable
from oven
Junction box
Red wires
Black wires
White wires
Bare or
green wire
U.L.-listed conduit
connector
Figure 2
Important: Use twist-on connector
with square-wire spring
Square-wire spring
Or
From the oven
Terminal Block
From power supply
For Installer
To Next Page
Loading...
