6.6 Items to Be Initialized by Changing Settings
6.6.1 MEWTOCOL/Modbus ASCII/Modbus RTU
If settings are changed, the following items will be initialized.
Yes: Initialized
No: Not initialized
Setting item
to be changed
Item to be Initialized
Input Type
(0002H)
Event output
EV1 allocation
(0006H)
Event output
EV2 allocation
(0007H)
output
(000BH)
SV1 to SV9 (1000 to 1018H)
Yes
No
No No
Steps 1 to 9 wait value (1002 to 101AH)
Yes
No No No
AT bias (005BH)
Yes
No No No
OUT1 proportional band (003CH)
Yes
No No No
Manual reset (0040H)
Yes
No No No
SV rise rate (0058H)
Yes
No No No
SV fall rate (0059H)
Yes
No No No
Scaling high limit (0003H)
Yes
No No No
Scaling low limit (0004H)
Yes
No No No
Program start temperature (006FH)
Yes
No No No
EV1 alarm value (0012H)
Yes Yes
No No
EV1 high limit alarm value (0013H)
Yes Yes
No No
Loop bread alarm time (001EH)
Yes
No No No
Loop bread alarm span (001FH)
Yes
No No No
SVTC bias (0053H)
Yes
No No No
Remote bias (0056H)
Yes
No No No
EV2 alarm value (0014H)
Yes
No
Yes
No
EV2 high limit alarm value (0015H)
Yes
No
Yes
No
Transmission output high limit (000CH)
Yes
No No
Yes
Transmission output low limit (000DH)
Yes
No No
Yes
OUT2 proportional band (0047H)
Yes
No No No
EV1 alarm value 0 Enabled/Disabled (0024H)
No
Yes
No No
EV1 alarm hysteresis (0025H)
No
Yes
No No
EV1 alarm delay time (0026H)
No
Yes
No No
EV1 alarm Energized/De-energized (0027H)
No
Yes
No No
EV2 alarm value 0 Enabled/Disabled (0028H)
No No
Yes
No
EV2 alarm hysteresis (0029H)
No No
Yes
No
EV2 alarm delay time (002AH)
No No
Yes
No
EV2 alarm Energized/De-energized (002BH)
No No
Yes
No
Sensor correction coefficient (004FH)
Yes
No No No
Sensor correction (0050H)
Yes
No No No
External setting input high limit (0054H)
Yes
No No No
External setting input low limit (0055H)
Yes
No No No
To Next Page
Loading...
