Panasonic KT4R - Page 56

6.6.2 KT4 Command
For KT4 command, if settings are changed, the following items will be initialized.
Yes: Initialized
No: Not initialized
Setting item
to be changed
Item to be Initialized
Input type
(0044H)
Event output
EV1 allocation
(0023H)
Event output
EV2 allocation
(0024H)
SV1 (0001H)
Yes
No No
AT bias (0047H)
Yes
No No
OUT1 proportional band (0004H)
Yes
No No
Scaling high limit (0018H)
Yes
No No
Scaling low limit (0019H)
Yes
No No
EV1 alarm value (000BH)
Yes Yes
No
Loop bread alarm time (0010H)
Yes
No No
Loop bread alarm span (0011H)
Yes
No No
EV2 alarm value (000CH)
Yes
No
Yes
OUT2 proportional band (0005H)
Yes
No No
EV1 alarm hysteresis (0025H)
No
Yes
No
EV1 alarm delay time (0029H)
No
Yes
No
EV1 alarm Energized/De-energized (0040H)
No
Yes
No
EV2 alarm hysteresis (0026H)
No No
Yes
EV2 alarm delay time (002AH)
No No
Yes
EV2 alarm Energized/De-energized (0041H)
No No
Yes
Sensor correction (0015H)
Yes
No
No
Phone: 800.894.0412 - Fax: 888.723.4773 - Web: www.clrwtr.com - Email: info@clrwtr.com