73
Troubleshooting
and Routine Care
Clearing a recording paper jam
If the unit does not eject any recording paper during reception or copying, the recording paper has jammed.
Remove the jammed paper as shown below.
4
Close the back cover by gently pressing down on
both corners of the cover.
●
A message is printed.
When the recoding paper is set to the wrong side,
a message is not printed. Install the recording
paper correctly.
3
Replace the transparent guide and recording paper
roll in the proper direction, and insert the leading
edge of the paper between the recording paper roller
and the silver plate.
●
Make sure that there is no slack in the paper roll.
2
Pull up the corners of the transparent guide and
remove the jammed piece of paper.
●
If the transparent guide is not pulled up, press the
green lever again.
1
Open the back cover by lifting up the tabs located
on both sides, and press the green lever to release
the paper cutter.
To Next Page
Loading...
