Panasonic KX-FL611

4. Fax
40
Note:
L If you program the wrong item, press {STOP}
after step 4 to erase the item.
L Confirm the stored items by printing a
broadcast programming list (page 72).
4.4.2 Adding a new item into the
broadcast memory
After initial programming, you can add new items
(up to a combined total of 20).
1 Press {>}.
L Confirm that there are no documents in
the document entrance.
2 Press {A} or {B} repeatedly to display the
desired broadcast memory
(“<BROADCAST1>”, “<BROADCAST2>” or
“<MANUAL BROAD>”).
3 Press {DIRECTORY PROGRAM}.
4 Press {*}.
5 Press {A} or {B} repeatedly to display the
desired item you want to add.
6 Press {SET}.
L To add other items, repeat steps 5 and 6
(up to 20 items).
7 Press {DIRECTORY PROGRAM} to exit.
Note:
L When adding new items to the MANUAL
BROADCAST memory, you can only select
stored items.
4.4.3 Erasing a stored item from
the broadcast memory
1 Press {>}.
L Confirm that there are no documents in
the document entrance.
2 Press {A} or {B} repeatedly to display the
desired broadcast memory
(“<BROADCAST1>”, “<BROADCAST2>” or
“<MANUAL BROAD>”).
3 Press {DIRECTORY PROGRAM}.
4 Press {#}.
5 Press {A} or {B} repeatedly to display the
desired item you want to erase.
L To cancel erasing, press {STOP}.
6 Press {SET}.
7 Press {SET}.
L To erase other items, repeat steps 5 to 7.
8 Press {DIRECTORY PROGRAM} to exit.
4.4.4 Sending the same
document to pre-programmed
parties
1 Insert the document FACE DOWN.
2 If necessary, press {RESOLUTION}
repeatedly to select the desired resolution
(page 37).
3 Press the desired {BROADCAST} (1-2) or
{MANUAL BROAD}.
L The document will be fed into the unit and
scanned into memory. The unit will then
send the data to each party, calling each
number sequentially.
L After transmission, the stored document
will be erased from memory
automatically, and the unit will
automatically print a report (broadcast
sending report).
Note:
L If you select “FINE”, “SUPER FINE”,
“PHOTO” or “PHOTO WITH TEXT”
resolution, the number of pages that the unit
can send will decrease.
L If the document exceeds the memory
capacity, sending will be canceled.
L If a party is busy or does not answer, it will be
skipped and redialed later.
To cancel broadcast transmission
1. Press {STOP} while “BROADCASTING” is
displayed.
L The display will show “SEND
CANCELED?”.
2. Press {SET}.
FL611-PFQX2072ZA-en.book Page 40 Thursday, December 21, 2006 11:10 AM