1.13. INSTALLATION
1.13.1. INSTALLING THE RECORDING PAPER
1 Open the cover by pressing the cover open button and install
the recording paper roll.
If the paper is secured with glue or tape, cut approximately 15
cm (6 inches) from the beginning.
2 Insert the leading edge of the paper into the opening above
the thermal head and pull it out of the unit.
· Make sure that there is no slack in the paper roll.
3 Close the cover securely by pushing down on both ends.
Display:
4 Press
· The whit will eject the paper slightly and cut it.
Note:
· Only use the included roll of paper or specified recording paper, or else the print quality may be affected and/or excessive
thermal head wear may occur.
· To order recording paper, see OPTIONAL ACCESSORIES (P.7).
· When the power cord is connected, every time you close the cover a message will be printed if the recording paper is set
to the wrong side, a message will not be printed.
Install the paper correctly.
· If you do not press
within 30 seconds after closing the cover, the whit will automatically eject the paper slightly
and cut it.
1.13.2. DOCUMENT STACKER
Install the document stacker.
13
KX-FT63BX / KX-FT63BX-W
To Next Page
Loading...
