2.2.2. PAPER JAM
1 Open the cover by pressing the cover open button .
Then lift the green lever to release the paper cutter and
remove the recording paper roll.
Note:
When the green lever is not released, press “4” key and
“STOP” key at the same time.
Then the green lever position is reset.
Caution:
· Keep your fingers away from the paper cutter.
· It dose not operate while the calling, the sending faxes and
the printing.
2 Cut off the wrinkled portion, and replase the recording paper
roll in the proper direction.
3 Insert the leading edge of the paper into the opening above
the thermal head and pull it out of the unit.
· Make sure that there is no slack in the paper roll.
· If the paper cannot be inserted, try lifting the green lever
again.
4 Close the cover securely by pushing down on both ends.
Display:
5 Press
· The unit whit will eject the paper slightly and cut it.
Note:
· When the power cord is connected. everytime you close the cover a message will be printed. If the recording paper is set
to the wrongside, a message will not be printed. Install the paper correctly.
· If you do not press
within 30 seconds after closing the cover, the unit will automatically eject the paper
slightly and cut it.
23
KX-FT63BX / KX-FT63BX-W
To Next Page
Loading...
