3. Preparation
9
Finding t he Controls
3.2 Overview
* The pictured model is KX-FT984.
Volu me
3.3 Adjusting volume
Ringer volume
While the unit is idle, press {A} or {B}.
L If any documents are in the document entrance, you
cannot adjust the volume. Confirm that there are no
documents in the entrance.
To turn the ringer OFF
1. Press {B} repeatedly to display “RINGER OFF=
OK?”.
2. Press {SET}.
L When a call is received, the unit will not ring and will
display “INCOMING CALL”.
L To turn the ringer back ON, press {A}.
Ringer tone
L You can select the ringer tone from one of 3 patterns
(feature #17 on page 29).
Handset receiver volume
While using the handset, press {A} or {B}.
Monitor volume
While using the monitor, press {A} or {B}.
Initial Pro gramming
3.4 Dialling mode
If you cannot dial (page 18), change this setting
depending on your telephone line service. For tone dial
service, select “TONE” (default). For rotary pulse dial
service, select “PULSE”.
1 Press {MENU}.
SYSTEM SETUP
PRESS [()]
2 Press {<} or {>} repeatedly to display the following.
DIAL MODE
=TONE [±]
3 Press {A} or {B} repeatedly to display the desired
setting.
4 Press {SET}.
L The next feature will be displayed.
5 Press {MENU}.
1 Speaker
2 Document guides
3 Paper stacker (KX-FT984 only)
L The paper stacker may not be shown in all
illustrations in these operating instructions.
4 Document feeder tray
5 Top cover
6 Document exit
7 Document entrance
8 Top cover release button
12 4
678
5
3
{A}{B}
{SET}
{A}{B}{<}{>}
{MENU}
{SET}
FT982_984HK-PNQX1347ZA-OI-en.book Page 9 Friday, June 13, 2008 10:35 AM
To Next Page
Loading...
