Initial setup (for Android device
us
ers)
Do not perform this procedure if
y
o
u want to integrate the
camera with your Home
Network System. Use the
procedure on page 22.
1 P
ress and hold the reset
b
utton on the back of the
camera for about 10 seconds,
and then wait for the camera’s
LED to light in yellow.
R The camera’s setting will be
reset.
2 Start the [Home Network]
app.
3 Tap [Set up the HD Camera].
4 When prompted, press the
MWi-Fi SETUPN button on the
camera.
R The LED indicator blinks in
yellow.
R The app temporarily
changes your mobile
device’s Wi-Fi setting so
that it connects to the
camera directly.
5 If necessary, enter the
password required to connect
to your wireless router and
then tap [Next].
R The camera and your
mobile device connect to
your wireless router.
6 When prompted, press the
MW
i-Fi SETUPN button on the
camera.
R Your mobile device will be
registered to the camera.
7 When prompted, follow the
on-screen instructions and set
the password used to log in to
the camera while away from
home.
8 When prompted, enter a
name for your mobile device
and then tap [OK].
R This setting allows you to
change the name assigned
to your device. It can help
you identify your mobile
device when performing
certain operations, such as
deregistering a mobile
device.
R The app’s home screen is
displayed when initial setup
is complete.
20
For assistance, visit www.panasonic.ca/english/support
Setup
To Next Page
Loading...
