3.5 Initializing the IP-CS
If the IP-CS does not operate properly, initialize the IP-CS. Before initializing the IP-CS, try the system feature
again to confirm whether there definitely is a problem or not.
The settings that are configured by using the IP Terminal Maintenance Console are changed back to their
factory default by initializing the IP-CS.
While initializing the IP-CS, calls cannot be made or received and ongoing conversations will be disconnected.
1. Switch the Initialized Mode switch from OFF to ON.
2. Supply electricity to the IP-CS using an AC adaptor, PoE hub, or PoE adaptor (turn on the IP-CS).
3. While the LED indicator flashes red (Moderate Flashing: 120 times per minute), switch the Initialized Mode
switch from ON to OFF.
Note
When the LED turns off for a while then flashes red, initialization is complete.
Quick Installation Guide 15
3 Installing the IP-CSs
To Next Page
Loading...
