Panasonic KX-NT511 - Attaching the Stand

CAUTION
R Before you install or uninstall the Add-on 48 key module, turn off the unit by
disconnecting the AC adaptor (if connected) and the Ethernet cable connected
to the switching hub.
Note
R Up to 4 Add-on 48 key modules can be connected. If 2 or more key modules are
connected, an AC adaptor must be connected to the second key module. If only
1 key module is connected, an AC adaptor is not required.
R Use only the Panasonic AC adaptor. See “Optional Accessories”, Page 6.
Attaching the Stand
KX-NT511/KX-NT551
1 Insert the catches of the stand into the hooks located in the unit.
2 Gently push the stand in the direction indicated until it locks into
place. The stand will be mounted.
Example: KX-NT551
KX-NT553/KX-NT556/KX-NT505
1 Insert the catches (
1
) of the stand into hooks located in the unit.
2 Gently push the stand in the direction indicated until it locks into
place. The stand will be mounted in the high position.
Example: KX-NT556
A
21
Installation and Setup