Panasonic KX-T7560 - Location of Controls; Adjusting the Ringer Volume; Adjusting the Display Contrast

— 6 —
Location of Controls
KX-T7565
LCD (Liquid Crystal Display)
INTERCOM: Used to make or receive
intercom calls.
The display and Microphone are not
available for the KX-T7560.
PROGRAM: Used to enter and exit the
programming mode. (For station
programming mode only. For system
programming, please use another Digital
Proprietary Telephone with display.)
FLASH/RECALL: Used to disconnect
the current call and make another call with
holding the same outside line.
AUTO DIAL/STORE: Used for speed
dialling in the system or storing program
changes.
TRANSFER: Used to transfer a call to
another party.
REDIAL (ordinarily): Used to redial.
PAUSE (in programming): Used to
insert a pause for One-touch dialling numbers.
HOLD: Used to place a call on hold.
SP-PHONE: Used for the handsfree
operation.
MONITOR (KX-T7560 only): Used for
handsfree dialling. You can monitor the
party’s voice handsfree.
Microphone: Used for the handsfree
conversation.
AUTO ANS (Auto Answer): Used to
answer an intercom call automatically
without touching telephone.
VOICE CALL (KX-T7560 only): Used to
monitor an intercom call automatically.
MUTE: Used to listen to the other party
without them hearing you. You can mute
the handset microphone or the Microphone.
VOLUME Control Button: Used to
adjust the volume.
Flexible Outside (CO) Line Button:
Used to make or receive an outside call,
or access a feature if the button is assigned
as a One-touch dialling button.
Adjusting the display contrast (KX-T7565 only)
While idle and on-hook, and not ringing
Press FLASH/RECALL button first. Press UP ( ) or DOWN ( ) key within
2 seconds after releasing FLASH/RECALL button. (3 steps)
Printed in Malaysia
PSQW1567YA-BM KK1000TT1013 (AL)
RINGER
Adjusting the ringer volume
Adjust the RINGER volume selector lever
(at the bottom of the unit) to the desired setting.
( – OFF, – LOW, – HIGH)