Useful Information
29
*1 KX-TG1611/KX-TG1711
Programmable settings
Battery recharge
Making/answering calls, intercom
Problem Cause/solution
I cannot use the intercom feature.
*1
L This feature is shared between the handsets.
Although the handset displays “Intercom”, this
feature is not available for this model.
Problem Cause/solution
The display is in a language I
cannot read.
L Change the display language (page 13).
Problem Cause/solution
The handset beeps and/or 8
displays.
L Battery needs charging. Fully charge the batteries
(page 10).
I fully charged the batteries, but
– battery level does not increase or
– the operating time seems to be
shorter.
L Clean the battery ends (S, T) and the charge
contacts with a dry cloth and charge again.
L It is time to replace the batteries (page 10).
Problem Cause/solution
w is flashing. L The handset is too far from the base unit. Move
closer.
L The base unit’s AC adaptor is not properly
connected. Reconnect AC adaptor to the base unit.
L The handset is not registered to the base unit.
Register it (page 31).
Noise is heard, sound cuts in and
out.
L You are using the handset or base unit in an area
with high electrical interference. Re-position the
base unit and use the handset away from sources of
interference.
L Move closer to the base unit.
L If you use a DSL/ADSL service, we recommend
connecting a DSL/ADSL filter between the base unit
and the telephone line jack. Contact your DSL/ADSL
provider for details.
L Unplug the base unit’s AC adaptor to reset the unit
and turn off the handset. Reconnect the adaptor, turn
on the handset and try again.
The handset does not ring. L The ringer volume is turned off. Adjust ringer volume
(page 16).
TG161x_171xFX(e).book Page 29 Monday, February 28, 2011 9:11 AM
To Next Page
Loading...
