Direct Commands
54
During programming:
When “Save” is displayed, press the right soft key to save the new settings.
To exit programming, press [OFF].
• If you press the direct command incorrectly, press [OFF], then re-enter
programming mode by pressing [MENU].
• For function details, see the corresponding pages.
Ringer tone
(for base unit)
[0] [*] [1] [1]–[3] : Tone pattern 1–3
[4]–[7] : Melody pattern 1–4
p. 17
Incoming call tone
(for base unit)
[0] [*] [2] [1] : On [2] : Twice [0] : Off p. 48
Talking Caller ID
(for base unit)
[0] [*] [4] [1] : On [0] : Off p. 26
Menu item Command Selection items Page
PQQX13985YA.book 54 ページ ２００４年１月２２日 木曜日 午後５時８分
To Next Page
Loading...
