Automatic Answering Operation
56
Monitoring Incoming Calls
While a caller is leaving a message, you can monitor the call through the base unit
speaker.
• To increase the speaker volume while monitoring, press VOLUME
[>]. To
decrease the volume, press VOLUME
[<].
To answer a call while monitoring, press [SP-PHONE] on the base unit or press
[C] or [s] on the handset.
To turn the incoming call monitoring feature off
When the base unit is not in use, press [GREETING CHECK], then press
VOLUME [] repeatedly until “0” is displayed. (Make sure the Answering
System is turned on.)
OR
While monitoring, press VOLUME [<] repeatedly until “0” is displayed.
• If the incoming call monitoring feature is turned off, it will remain off when the next
call is monitored.
• If you adjust the speaker volume while playing back messages or using the
speakerphone, the speaker volume for monitoring will be turned on again. To turn
the speaker volume off, see “To turn the incoming call monitoring feature off” of
above step.
Base Unit
>
PQQX13991YA.book 56 ページ ２００４年２月２５日 水曜日 午前１１時１２分
To Next Page
Loading...
