Direct Commands
70
During programming:
When “Save” is displayed, press the right soft key to save the new settings.
To exit programming, press [OFF].
• If you press the direct command incorrectly, press [OFF], then re-enter
programming mode by pressing [MENU].
• For function details, see the corresponding pages.
*
1
You need to first download melody data from the openLCR web site.
*
2
Can be used to activate Caller IQ. See the leaflet included with this unit for more
information.
*
3
For openLCR subscribers only.
*
4
For openLCR subscribers only. If information is not downloaded to your unit, “Get
new Info.?” will be displayed. To download information, see page 80.
*
5
After pressing [7], make sure “View Info.?” is displayed, then press the next
command.
If Caller IQ is turned off, “Turn CIQ on?” is displayed after pressing [7].
Set flash time [0] [5] [2] [1] : 700 ms [2] : 600 ms
[3] : 400 ms [4] : 300 ms
[5] : 250 ms [6] : 110 ms
[7] : 100 ms [8] : 90 ms
p. 52
Set line mode [0] [5] [3] [1] : A [2] : B p. 16
Number of rings [0] [6] [1] [2]–[7] : 2–7 rings
[0] : Toll saver
p. 23
Recording time [0] [6] [2] [1] : 1 minute [2] : 2 minutes
[3] : 3 minutes
[0] : Greeting only
p. 22
Remote code [0] [6] [3] Go to Step 5 on page 63. —
Recording mode [0] [6] [4] [1] : Standard recording
[2] : Enhanced recording
p. 24
Change language [0] [8] [1] : English [2] : Spanish p. 15
Message alert [0] [#][1] : On [0] : Off p. 24
Ringer tone
(for base unit)
[0] [*] [1] [1]–[3] : Tone pattern 1-3
[4]–[7] : Melody pattern 1-4
[8]–[9] : Downloaded melody
pattern 1-2 *
1
p. 19
Incoming call tone
(for base unit)
[0] [*] [2] [1] : On [2] : Twice [0] : Off p. 53
Talking Caller ID
(for base unit)
[0] [*] [4] [1] : On [0] : Off p. 32
Menu item Command Selection items Page
PQQX13991YA.book 70 ページ ２００４年２月２５日 水曜日 午前１１時１２分
To Next Page
Loading...
