Using Bluetooth devices
Problem Cause/solution
I cannot copy phonebook
e
ntries from a cellular phone.
R Confirm that the cellular phone supports Bluetooth
wireless technology.
R Confirm that the cellular phone supports the Phone Book
Access Profile (PBAP) or Object Push Profile (OPP)
specification.
R If the cellular phone is already connected to another
Bluetooth device such as a Bluetooth headset, turn it off
or disconnect it from the cellular phone.
R Someone is using a cellular line or headset. Try again
later.
R Turn the cellular phone off, then turn it on and try again.
R If an entry is already stored in the unit’s shared
phonebook, the entry cannot be copied even by selecting
another group.
I cannot have a conversation
u
sing the headset.
R Your Bluetooth headset is not registered. Register it
(page 47).
R Turn your headset off, then turn it on and try again.
Noise is heard during a call on
t
he headset.
R A Bluetooth headset can communicate with the base unit
within a range of approximately 10 m (33 feet). The
connection may be subject to interference from
obstructions such as walls or electronic devices. Move
closer to the base unit.
I cannot connect my headset to
t
he base unit.
R Confirm that your headset is turned on.
R If your headset is already connected to another Bluetooth
device such as your cellular phone, disconnect the
headset from your cellular phone, then perform the
connecting procedure from the base unit.
R If someone is using a cellular line, you cannot connect the
headset. There can be only one active Bluetooth
connection at a time.
R The headset has not been registered to the base unit.
Register the headset (page 47).
Some headset enhanced
f
eatures are not available.
R The base unit does not support enhanced features such
as Last number redial or Call reject.
An error tone is heard when I
t
ry to program the Bluetooth
feature.
R The Bluetooth feature cannot be accessed immediately
after connecting the AC adaptor to the base unit. Wait a
few seconds and try again.
R The headset has not connected to the base unit yet, even
though you performed the connecting procedure setting.
Wait a few seconds and try again.
For assistance, please visit http://www.panasonic.com/help
67
Useful Information
TG7731_41_(en-en)_1121_ver.021.p67 67 2011/11/21 12:02:15
To Next Page
Loading...
