Error messages
Display message Cause/solution
Ask phone
c
ompany for
VM access #
R Y
ou have not stored the voice mail access number. Store the
number (page 46).
Base no power
o
r
No link. Re-
connect base
AC adaptor.
or
No link.
R The handset has lost communication with the base unit. Move
closer to the base unit and try again.
R Unplug the base unit’s AC adaptor to reset the unit.
Reconnect the adaptor and try again.
R The handset’s registration may have been canceled.
Re-register the handset (page 35).
R When “No link.” is displayed during a power failure, place
a handset on the base unit to supply power to the base unit.
Busy
R T
he called unit is in use.
R Other units are in use and the system is busy. Try again later.
R The handset you are using is too far from the base unit. Move
closer and try again.
Check tel line
R T
he supplied telephone line cord has not been connected yet
or not connected properly. Check the connections (page 10).
Error!!
R R
ecording was too short. Try again.
Invalid
R T
here is no handset registered to the base unit matching the
handset number you entered.
R The handset is not registered to the base unit. Register the
handset (page 35).
Requires
s
ubscription
to Caller ID.
R You must subscribe to a Caller ID service. Once you receive
caller information after subscribing to a Caller ID service, this
message will not be displayed.
Use
r
echargeable
battery.
R A wrong type of battery such as Alkaline or Manganese was
inserted. Use only the rechargeable Ni-MH batteries noted on
page 5, 7.
50
For assistance, please visit http://www.panasonic.com/help
Useful Information
TGE21x23x24x(en)_1122_ver031.pdf50 50 2013/11/22 14:22:30
To Next Page
Loading...
