Problem Cause/solution
I cannot register a handset to a
b
ase unit.
R The maximum number of handsets (6) is already
registered to the base unit. Cancel unused handset
registrations from the base unit (page 41).
Battery recharge
Problem Cause/solution
The handset beeps and/or
flashes.
R B
attery charge is low. Fully charge the batteries (page 11).
I fully charged the batteries, but
–
still flashes,
– is displayed, or
– the operating time seems to
be shorter.
R C
lean the battery ends (
, ) and the charge contacts
w
ith a dry cloth and charge again.
R It is time to replace the batteries (page 10).
Making/answering calls, intercom
Problem Cause/solution
is displayed.
R T
he handset is too far from the base unit. Move closer.
R The base unit’s AC adaptor is not properly connected.
Reconnect AC adaptor to the base unit.
R The handset is not registered to the base unit. Register it
(page 41).
Noise is heard, sound cuts in
a
nd out.
R You are using the handset or base unit in an area with
high electrical interference. Re-position the base unit and
use the handset away from sources of interference.
R Move closer to the base unit.
R If you use a DSL/ADSL service, we recommend
connecting a DSL/ADSL filter between the base unit and
the telephone line jack. Contact your DSL/ADSL provider
for details.
The handset does not ring. R T
he ringer volume is turned off. Adjust the ringer volume
(page 17, 33).
R Silent mode is turned on. Turn it off (page 38).
R The ringer volume is turned off by pressing and holding
0 (
). Turn it on again (page 17).
The base unit does not ring. R T
he ringer volume is turned off. Adjust the ringer volume
(page 17).
R Silent mode is turned on. Turn it off (page 38).
I cannot make a call. R T
he dialing mode may be set incorrectly. Change the
setting (page 15).
56
For assistance, please visit http://shop.panasonic.com/support
Useful Information
KX-TGE63x_64xUSA_(en)_1213_ver031.pdf 56 13/12/2017 4:29:19 PM
To Next Page
Loading...
