8.1. Engineering Mode
8.1.1. Base Unit
Important:
Make sure the address on LCD is correct when entering new data. Otherwise, you may ruin the unit.
1). Press {MENU}.
2). Select "Settings" using or
then press
{SELECT} or {>}.
H/S key operation
H/S LCD
{^} {V}
3). Enter "7", "2", "6", "2", "7", "6", "6", "4".
Note: 7262 7664 = PANA SONI
(see letters printed on dial keys)
5). Enter "
ە
", "
ە
", "
ە
", "
ە
" (Address). (*1)
6). Enter "
㸨
", "
㸨
" (New Data). (*1)
4). Select "Write EEP" using or
then press
{SELECT} or {>}.
{^} {V}
Default Data
Select "Set tel line" using or
then press
{SELECT} or {>}.
{^} {V}
Service Mode
Read EEP
Write EEP
Set Addr.:
Soft keys
Navigator key/
VOL.(Volume) key
{OFF}
{FLASH}
{CALL WAIT}
Dial keypad
BACK
SELECT
CLEAR
OK
This picture model is KX-TGF370
To Next Page
Loading...
