Problem Cause/solution
I cannot use a cellular line or a
l
andline.
R The unit can be used to talk on 2 lines at the same time (for
example, 2 cellular lines, or the landline and 1 cellular line).
I cannot make long distance calls. R M
ake sure that you have long distance service.
Caller ID/Talking Caller ID
Problem Cause/solution
Caller i
nformation is not displayed. R You must subscribe to Caller ID service. Contact your phone
service provider for details.
R If your unit is connected to any additional telephone equipment
such as a Caller ID box or cordless telephone line jack, plug the
unit directly into the wall jack.
R If you use a DSL/ADSL service, we recommend connecting a
DSL/ADSL filter between the base unit and the telephone line
jack. Contact your DSL/ADSL provider for details.
R The name display service for landline calls may not be available
in some areas. Contact your phone service provider for details.
R Other telephone equipment may be interfering with this unit.
Disconnect the other equipment and try again.
Caller information is displayed or
a
nnounced late.
R Depending on your phone service provider, the unit may display
or announce the caller’s information at the 2nd ring or later.
R Move closer to the base unit.
Caller information is not
a
nnounced.
R The ringer volume for landline is turned off. Adjust the ringer
volume (page 21, 25, 41).
R The ringer volume for cellular line is turned off. Adjust the ringer
volume (page 21, 25, 39).
R The unit which is not selected to ring for cellular calls does not
announce caller information. To change the selection, see
page 17.
R The Talking Caller ID feature is turned off. Turn it on (page 41).
R The ring as cell mode is set to “On (without Talking
CID)”. To change the mode, see page 17.
R The number of rings for the answering system is set to “2
rings” or “Toll saver”. Select a different setting (page 62).
R Your unit does not announce caller information while the other
devices such as headset or handsets are engaged in a call.
The caller list/incoming phone
n
umbers are not edited
automatically.
R The Caller ID number auto edit feature is turned off. Turn it on
and try again (page 42).
R You need to call back the edited number to activate Caller ID
number auto edit.
I cannot dial the phone number
e
dited in the caller list.
R The phone number you dialed might have been edited
incorrectly (for example, the long distance “1” or the area code
is missing). Edit the phone number with another pattern
(page 50).
Time on the unit has shifted. R I
ncorrect time information from incoming Caller ID changes the
time. Set the time adjustment to “Manual” (off) (page 41).
For assistance, please visit http://shop.panasonic.com/support
71
Useful Information
To Next Page
Loading...
