Panasonic KX-TGF382 - Getting Started; Connections; Handset Battery Installation

Setting up
Connections
R I
f you do not connect the telephone line cord
and use only cellular lines, set the cellular line
only mode to use this unit more conveniently
(page 18).
n Base unit
Connect the AC adaptor to the unit by
p
ressing the plug firmly.
Connect the telephone line cord to the unit
u
ntil you hear a click.
Fasten the AC adaptor cord and the telephone
l
ine cord by hooking it.
Connect the AC adaptor to the power outlet.
Connect the telephone line cord to the
s
ingle-line telephone jack (RJ11C) until you
hear a click.
A DSL/ADSL filter (not supplied) is required if
y
ou have a DSL/ADSL service.
Connect the corded handset cord to the
c
orded handset and the base unit until you
hear a click.
7
7
1
4 6
5
1
2
3 3
3
Note:
R U
se only the supplied Panasonic AC adaptor
PNLV226.
R F
ollow the directions on the display to set up
the unit.
n C
harger
Connect the AC adaptor to the power outlet.
1
Handset battery installation
R U
SE ONLY rechargeable Ni-MH batteries AAA
(R03) size (
1
).
R D
o NOT use alkaline/manganese/Ni-Cd
batteries.
R Confirm correct polarities (
, ).
1
R F
ollow the directions on the display to set up
the unit.
Handset battery charging
C
harge for about 7 hours.
R Confirm “Charging” is displayed (
1
).
R W
hen the batteries are fully charged, “Fully
charged” is displayed.
1
For assistance, please visit http://shop.panasonic.com/support
9
Getting Started
TGF380_TG590SK(en-en)_0907_ver201.pdf 9 2016/09/07 12:38:10